Farmall & IHC Tractors Discussion Board |
Re: FARMALL 400 HITCH
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on November 28, 2005 at 05:55:47 from (209.226.106.66):
In Reply to: FARMALL 400 HITCH posted by CARLOSGENARO on November 28, 2005 at 00:01:22:
Carl: Are you absolutely sure there are no hydraulics. I have some questions. Are there levers on side of hood, just to the right of the dash? These would be about 7" long with a round knob slightly smaller than a golf ball. There may be 1, 2 or 3 of those levers. Are there two steel tubes, one about3/4" the other about 1' running parallel to each other from under dash along the right side to a pump mounted between distributor and timing gear case? These would be visable just below hood to back of engine then they dip to level of frame rails along engine. If indeed you have those items you do have hydraulics. It's very rare to find a Farmall 400 with no hydraulics, not unheard of though.
Replies:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|