|
Farmall & IHC Tractors Discussion Board |
one last hydro pump question, honest!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by fenton on November 27, 2005 at 05:09:14 from (64.136.49.226):
On the gear shaft housing, I had mentioned TWO grooves, one filled with a seal(the culprit letting fluid into the engine) and just a quarter inch in is a identical groove which is empty. Now, the question. As I might need a speedy sleeve, and machine the hole bigger to fit the saft back into the hole, did IH make that second identical groove to accept the new seal, making it a tighter fit and no need for the speedy? It's empty and I can almost tell you guys, never had a seal in it. It would be in an area on the shaft not worn and seems like it might be the reason IH put it there. I'm going to bring the pump to the IH shop and ask them but wanted to get your take on the looooong hashed out subject. I promise this is it and if IH says yes, I'll pass it onto this site.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Mud Daubers and the Old John Deere - by Jon Zehnder. I have a 1941, John Deere Model A tractor I have owned for about a year and a half. This is my first (in case my wife reads this, "FIRST") tractor and it has been a learning experience. After considerable advise and assistance from local tractor nuts and the forums of Yesterday�s Tractors, I had finally got it running pretty well. I have tuned it up, overhauled the carburetor, installed a borrowed, rebuilt magneto, installed a new Power-Trol, patched the radiator, installed new front wheels a
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
