|
Farmall Tractors Discussion Board |
Touch Control Fluid
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Stan on December 31, 1999 at 15:41:03 from (12.67.147.16):
Changed the touch control fluid in my Super A for the first time today.
When I pulled out the filter it was caked with crud ! It also had at least two splits about 1/4" to 1/2" long. I don't think it's been doing any filtering in quite a while. I don't think there were any metal shavings in the crud. It seemed to roll through my fingers very softly. Should I flush the system ?? if so how?? Also when both controls are pushed towards the front every thing moves very easily. When both control are pulled towards the seat the tractor labors harder. Is this normal or a point of concern. Thanks in advance for any help.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Threshin Demonstration - by Michael Delaney. Introduction I bring you greetings from Prince Edward Island, Canada. We are Canada�s smallest province but big on farming. Maybe you�ve heard of us. Potatoes are our biggest crop. However, there is lots of mixed farming here also. I have a small mixed farm with 25-30 cattle. I make very good use of old machinery. I have a 135 MF Diesel, Farmall H and 1/3 share in an Allis B. I have complete lines of tillage and harvest equipment, and a saw gear etc. I have everything one would
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
