|
Farmall & IHC Tractors Discussion Board |
IH 330 Utility Questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tweeter on November 20, 2005 at 13:23:09 from (72.9.21.198):
I replaced all the electrical wiring on the 330U 12 volt and it starts and runs as I intended it to. But, the ammeter finger shakes about the 0 mark. I tried switching the wires on the posts and got the same results. The finger doesnt move at all when I start it up, once it is running then it will jiggle about 0. I know the ammeter on my 12 volt Ford will show +25 at half idle on the ammeter and will always half a charged battery. I have MOPAR alt on the 330U and am wondering if it is bad, if I replace it I would like to put a alt with a single post (I think 10SI) and not have an external regulator. How do I know what alt to get for the tractor? What will fit? I also noticed a hissing noise while the tractor is running. Im postive that it is hydraulics internally. Is that normal?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
