|
Farmall & IHC Tractors Discussion Board |
Re: RE: 434 IH Starting
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Janicholson on November 09, 2005 at 15:04:59 from (199.17.6.175):
In Reply to: Re: RE: 434 IH Starting posted by AL Sproule on November 09, 2005 at 14:27:32:
If you read my post above and look at #1 in the list, it indicates a wire attached to the battery cable connection (10ga.). This wire goes to the amp gage only. It connects to the same polarity as the battery terminal connected to the solenoid. If there is no wire, that is your problem. If it is there it may be a broken wire inside, or at a terminal. The amp meter is suposed to have battery voltage at both sides all the time. If it does on the side with the wire i have been describing but not the other, then it is broken, and cannot be fixed. The wires from the other side of the amp gage go to lights and the ign sw.
See bob M wiring diagrams. (and add my starting resistor bypass as in my other post).
JimN
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
