Dumb C timing question-Sorry

Posted by Dave BN on October 23, 2005 at 13:22:06 from (64.12.117.13):

Sorry to ask a dumb question but I can't get this thru my thick head. While installing a new distributer cap today noticed that my distributer is installed 180 degrees from what it should be. I know this for two reasons. The wire for #3 cylinder is on the post marked #1 on the cap. That doens't matter as long as you are aware of it. The real problem is that the zerk fitting for the distributer shaft is pointing towards the engine and there is no way to get a gun on it. I want to be able to grease this but the engine runs so good I hate to mess with it. Here's the question, if I mark the position of the rotor and spin the body of the distributer 180 degrees will I still be in time? Thanks for any help, Dave.

Follow Ups:

• Re: Dumb C timing question-Sorry El Toro 17:01:24 10/23/05 (0)
• Re: Dumb C timing question-Sorry old 13:35:02 10/23/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]