Farmall & IHC Tractors Discussion Board |
Farmall B front bearing replacement.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave H (MI) on October 14, 2005 at 14:16:55 from (64.12.117.13):

Well, I'm toast now. Had some time today so I took the hub apart on the B following the directions in my box kit of genuine Case-IH wheel bearing replacements. Now this kit says nothing about the B, only the A, AV etc...but the parts guy says it is the right thing. My usual procedure of taking the old off and putting the new back on the same way is not gonna work because the larger of the two bearing cones had disentegrated into a grease and steel slurry inside the hub and had destroyed a few other parts in the process. Since the new parts look nothing like the junk that came out, I am flying by the seat of my pants. I need help! First things first. There should be a picture of the spindle as part of this post. The spindle...working from the outside in...consists of a threaded part for the crown nut that holds it all together, then a smooth area for the outer bearing, then a pitted rough center section, then another smooth area for the inner bearing, and finally a slightly raised smooth are which I suspect must be for a seal. The guy before me ran the tractor with the bearing shot and there is some wear of the shoulders between the rough center section and the two bearing surfaces of the spindle. I guess my first question would be is this spindle damaged to the extent I need to replace it? I tried to show the extent of the wear in the photo. Hope it is clear enough.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|