|
Farmall & IHC Tractors Discussion Board |
Re: Restored '66 1206: Let Me Know Your Thoughts
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on October 12, 2005 at 17:15:37 from (4.124.77.118):
In Reply to: Restored '66 1206: Let Me Know Your Thoughts posted by Aaron on October 12, 2005 at 05:59:37:
They could have used the correct white along with the correct decals . So if that is not correct then what else is not done wright ?? Sorry i am so fussy but that is me and as far as spending the 10 grand to someone else and going by hearsay . I would rather by a rag and spend the whole winter Pulling one down to the running gears of a kaddyDID and DIY but then again that is me I just love the tear them down and throw the parts on the floor and see if i can make it run with less parts then it came with.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
