|
Farmall & IHC Tractors Discussion Board |
!!! HELP !!! H Gasket Set What the Heck Is This???
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MagMan on October 01, 2005 at 13:47:04 from (64.12.117.13):
OK This one has got me and that seems to be pretty easy these days.
Ok I have a Victor Reinz Gasket Set for a u164 or C152 Ok does any one know what this stough is
Crank shaft dust seal,Crank shaft rear oil seal retainer Ret. Plate, Generator conecting rod Housing, 1 Gear cover, 1 Gear cover (1/32),1 mag bracket, 1 mag bracket (1/32),What are the 1/32" gaskets for? it also says 1 water pump seal, 1 water pump body,1 water pump outlet elbow,They also included 2 oil pump cover gaskets, Is this for shimming or something They are both the same size, My pump now has one andI had it checked at the machine shop he said it was really good. Why would you shim it farther apart from the pump gears by using 2 gaskets ? I dont know maybe this is all elementary and I am just to stressed these days to figure it out. But any help would be appreatiated.
JON
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Engine Basics: Spark Plug Cleaning - by Staff. Cleaning procedures: Brush or blow dirt from around the spark plug base. Remove the plug with a correctly fitted wrench. Examine the porcelain insulator and points. If the insulator appears to be melted or blistered, cracked or broken, and the points seem unduly burned it is evident that the plug is operating too hot and it should be replaced with a colder plug. If the plug is fouled excessively with carbon it apparently is operating too cold and it should be replac
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
