Retcol said: (quoted from post at 16:54:56 04/06/09) Although I haven't got any plates from him, Robert Diener in Morgantown, W. Va has them. I don't know the cost.[/quote:b2e3a79046]
[quote:b2e3a79046="Old-F20"]Roberts tags HANDS DOWN will make anyone elses look like crap PERIOD!!.
I don't have quite the first hand Old-F20 does, but I just spoke with Robert today regarding 15-30 tags (I don't have an original [but know where to find one], and it's not my tractor right now, so I can't say it will be a go, but Robert noted he is interested if it works out on my end). His tags are not outsourced; actually he has them blanked by one of the companies that had made them for IH in the first place. Just some of the ideosyncracies he noted regarding various models he's made already, not to mention attention for detail in general, I have no doubt he is meticulous to detail.
They are more expensive than the ones I've seen on the internet, but I'd suspect both the quality and "correctness" are each of proportional degree to the price vs. those - so if both are important to you, you're probaby getting a bargain paying more. Then again, no first hand yet, so only a guess.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
