Farmall & IHC Tractors Discussion Board |
Re: 686 Question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan in NE on September 25, 2005 at 05:33:51 from (148.78.243.24):
In Reply to: 686 Question posted by Carp on September 24, 2005 at 14:12:15:
Hi Carp, They smoke on startup, need the either when it gets below 50 degrees and are nosier than you can ever imagine when they are pulling hard. Even so, if you don't want that 310, let me know where it is and I'll come get it, 'cause I've never been so impressed with an IH tractor in all my life when it comes time to work and I've owned a lot of 'em. Bottom line is, if you are just going to use it to putz around with, I'd leave 'er set 'cause you'll hate it. But, if you're after a workhorse, you'd better grab that thing before someone else finds out it's for sale. I bought a brand spankin' new 766 with a 360D in '75; this old 686 with the 310D having 7034 hours a couple of years ago. The 310 impresses me more. A 100 guys told me that it wouldn't handle an 18.5 Vibrashank. Baloney! Couldn't even get 'er to smoke at 5 mph. I just can't say enough good about 'em. Allan 

Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|