Farmall & IHC Tractors Discussion Board |
Flail and Rotary Mowers
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John Elwell on September 19, 2005 at 19:35:53 from (68.160.184.222):
I have two mowers and need information about both of them. 1. The first mower is a MOTT Flail mower serial # 582 Model SA5. I need to know what size pully is used off the PTO shaft and what pulley attachment is there that guides the belt to the pulley on the mower. It appears that i will need the PTO pulley and the pully attachemtn between the PTO and the mower. If anyone has a manual or picture as to how it is hooked up and also knows where I can get the needed pulleys, it would be greatly appreciated. 2. Today I picked up an IH three blade belly mount mower serial number 3100161U014964. I am assuming that it goes on a Framall 100 series, but might be wrong. Can someone tell me if I am correct. Again I need the pulley attachment between the PTO pulley and the mower pulley. A dioagram or picture of how this hooks up would be greatly appreciated also. I appreciate any assistance that the good folks on this site can give... John
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|