Farmall & IHC Tractors Discussion Board |
Re: Hydraulic Problems Farmall 450
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by P Backus on September 17, 2005 at 15:22:26 from (69.128.32.135):
In Reply to: Re: Hydraulic Problems Farmall 450 posted by David Kube on September 15, 2005 at 20:54:05:
Do you use the hydraulics? If so, does it seem to have enough pressure? If the relief valve was stuck open, you wouldn"t have any pressure and things wouldn"t work. To check the pump, I just got a pressure gauge rated for 3000 psi., and hooked it up to the appropriate hydraulic coupling. This tells me if it is developing enough pressure, but tells nothing about the flow rate. There are fancier ways to check the hyd system, but I don"t think that will help your problem. (By the way, I THINK the pressure on the 450 hydraulics should be about 1250psi.........give or take) What about the pumps? Were they rebuilt? Often a seal will leak when the bushing or bearing gets sloppy and that works on the seal. Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|