|
Farmall & IHC Tractors Discussion Board |
Re: 656 Gas Usage - Nebraska Test Results
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim Allen on September 08, 2005 at 05:18:40 from (209.173.160.22):
In Reply to: 656 Gas Usage - Nebraska Test Results posted by Nathan in Texas on September 07, 2005 at 13:24:26:
These numbers are about right on average. A diesel does about 25 percent more work for the same amount of fuel as a gasser. Still, as TractorVet says, the difference can be negligable on small acre farms considereing the lower prices of the gassers out there. I'm a diesel guy and it gives me hives to have to say it! I was getting desperate to find the right tractor at the right price and started looking at gassers because they are so much cheaper than diesels. I crunched the numbers and it would have taken about 10 years for the fuel savings of a diesel to make up the difference in price between the diesel tractor I wanted and the gasser I could afford. I was lucky enough to find the diesel I wanted at a good price, but I came very close to owning a 4020 gasser. The other element upcoming that could narrow the gap again is the new "emissions friendly" diesel fuel formulations coming up in '06 and '07. This fuel will be more expensive than the current (peewater) diesel. Some say 10 to 15 cents more expensive. It will be good fuel, though, better than what we've had. Gas and diesel have been running very close to the same price for the past few years and an extra .10-.15 might make them virtual equals.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|