Farmall & IHC Tractors Discussion Board |
Re: super c hydraulics help needed
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on August 28, 2005 at 12:47:29 from (66.43.221.67):
In Reply to: super c hydraulics help needed posted by DSS on August 28, 2005 at 10:53:51:
Measure the distance from pin to pin in the cycl when the hitch is at the height desired to pull the drill. Then drill two holes in a piece of metal 1/2x2 that dimension. Block the drawbar at desired hieght and remove the cycl and remove the cycl. Replace with the piece of metal then you can add enough hose to go the drill. why not put quick couplers on the cycl and make up new hoses to reach the drill. Then you can use the cycl in future for other purposes. Just remember there is a retarder in the line by the seat support so the drill will go down slowly but whats the hurry. 3/8 hose will be large enough to move the drill as thats the size of the lines running to the cycl now. good luck have fun. Now you can put the cycl on the disc.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|