|
Farmall & IHC Tractors Discussion Board |
Re: broken crank....ouch!!! need help!!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmersid on August 22, 2005 at 05:09:08 from (130.15.62.140):
In Reply to: broken crank....ouch!!! need help!!! posted by Perry County Farmalls on August 21, 2005 at 18:32:20:
The H crank will fit in the 350 block. Just make sure you order bearings for the H crank. I just put an H crank in a 350 block this spring. Also, if I remember correctly, measure the journal diameters on the H crank and make note of the dimensions. The diameters changed once I think through the production of the H. If you have the old bearings for that H crank, look on the back side of them and they will tell you if they are undersized or not. They should have STD, 0.010, or 0.020 stamped on them. The IT manual will tell you what sizes the journal diameters are based on the serial number of the tractor that the crank came out of. Hope this helps ya. Cheers! Sid
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
