Farmall & IHC Tractors Discussion Board |
Re: New tube in tire
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Nat on August 17, 2005 at 19:16:19 from (64.80.108.52):
In Reply to: New tube in tire posted by holcombwa on August 17, 2005 at 18:23:29:
NO, you don't have to be a mechanic for the manual to be useful. You just have to be patient and willing to do some homework... No manual is going to lay it all out for you. As for the tire, it'll be pretty obvious what needs to be done once you get it off the bead and see inside. There will probably be lots of rust and crud. Clean it out, maybe even give the inside of the rim a coat of rust-inhibiting paint? Make sure the rim is solid and there are no thin spots or holes. No point in putting a tire back on a rim that's going to collapse under its own weight... Generous use of a thick dish soap and water solution on the rim and tire beads will help things slip back together easily. Be careful and make sure the tires aren't "loaded," that is they don't have fluid in them. That calcium chloride really stings...
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|