|
Farmall & IHC Tractors Discussion Board |
Re: MCV ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Weldon on July 28, 2005 at 18:36:47 from (71.28.70.114):
In Reply to: Re: MCV ? posted by farner fireman on July 28, 2005 at 14:33:25:
The MCV (Multiple Control Valve)is located on the left side of the clutch/transmission housing.From your clutch pedal, follow the clutch operating rod toward the front where it connects to the clutch operating lever. Just beneath and a little toward the rear from the clutch lever you will see a plate about six inches wide and eight inches long (downward).It has many small bolt heads on it . This is the MCV body. Inside it is a small hydraulic pump and the valves that direct the oil supplied by this pump, to be sent to the steering, brakes and Torque Amplifier (if so equipped). It is my recommendation to you to get a repair manual for this tractor before attempting any repairs yourself. I&T Shop Manual will be sufficient. Cost maybe $25.00. Lots of info for the money.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|