Farmall H Hand Crank

Posted by ccairns on July 24, 2005 at 11:10:40 from (209.42.82.225):

I have a 49 Farmall H. The shaft that extends out the front has a hole real close to the end of the shaft and then I see where it looks like there may have also been a hole a bit further back that was later filled-in.

When I place the crank on the shaft it looks like if the original hole were still there it would matched the notch in the crank perfectly.

Do you know of any reason they would have filled the old hole and made a new one near the end?? It seems a bit odd. Also since the pin is missing what type of pin was used?

Is that assembly difficult to remove if I decide to drill a new hole?

Follow Ups:

• Re: Farmall H Hand Crank Wayne Swenson 15:53:09 07/24/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]