Re: Oil Pump

Posted by El Toro on July 19, 2005 at 14:27:24 from (205.188.117.73):

In Reply to: Oil Pump posted by Plains Hunter on July 19, 2005 at 12:08:48:

I know the IH manual call for .002"-.003" clearance, but I think it should be .001-.0015"
and I'm not sure if the Super A has cam bearings.
The A, B and C used the block bore with no bearings. What weight oil are using? I always used 30wt. It will get very thin too, on a hot day. Too much clearance on the cam will cause low
oil pressure. Hal

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]