Farmall & IHC Tractors Discussion Board |
Re: F12/F14 Timing/fail to start
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DA@STL on July 13, 2005 at 17:45:24 from (24.217.241.105):
In Reply to: Re: F12/F14 Timing/fail to start posted by Pete in Holland, MI on July 12, 2005 at 21:46:13:
A little update. According to the info I have the float is set for 3/4 full. I have a new pushrod, float valve seat, and carberutor gasket on order. I've installed the new plugs. One interesting thing, I didn't find any gas in the carb or the lines. I've already rebuilt the fuel pump, tore it apart today to see if I had the new check valves in correctly (yes) and bench tested it. Seems to work fine. So awaiting new parts and will reprime the lines and then crank her over. BTW, she was running before I started the rehab, so I don't think I'm too far off on the original settings. I'll keep you posted.
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|