Re: OT-How to close a Cold Shut?

Posted by Bus Driver on July 10, 2005 at 13:43:21 from (66.226.36.126):

In Reply to: Re: OT-How to close a Cold Shut? posted by Bob M on July 10, 2005 at 08:32:21:

I too have found the vise to be the best method. Sometimes the eye is not aligned correctly and the vise is helpful to push the rod end into alignment with the eye. I force the pin end out slightly through the eye and then weld over that end with a stick welder and 6011 rod- 80 to 100 amps.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]