Super C question

Posted by TXfarmall on July 07, 2005 at 20:42:03 from (71.97.97.48):

I have an old 54 farmall super C with a 123ci engine that I'm rebuilding the engine on.

I have a complete kit and I need to get the head down to a machine shop for guide installation and valve grinding.

Anyone know where I can get the specs/clearances/valve grind angles etc. for the head work so the machinist knows how to get the job done right?

These engines sure are tough, the poor thing ran the last ten years with a cracked piston. It's done well for a free tractor, have just been using it for light mowing and keeping a 1/4 mile of gravel drive maintained.

Can't wait to se what it does with new valves/springs/pistons and sleeves. I bet runs so good I'll have to repaint and restore it.

Also what's the best way to get a line on a fast hitch setup or hydraulic operated three point hitch?

Follow Ups:

• Re: Super C question farmallhal 06:39:03 07/08/05 (0)
• Re: Super C question El Toro 03:34:26 07/08/05 (4)
  • Re: Super C question Ken K. 17:29:21 07/08/05 (3)
    • Re: Super C question El Toro 04:09:34 07/09/05 (2)
      • Re: Super C question Ken Koch 11:26:07 07/09/05 (1)
        • Re: Super C question El Toro 12:25:10 07/09/05 (0)
• Re: Super C question Bob 00:47:06 07/08/05 (2)
  • Re: Super C question Calif. Farmall 01:48:52 07/08/05 (1)
    • Re: Super C question TXfarmall 14:37:20 07/12/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]