Farmall & IHC Tractors Discussion Board |
Re: 300 row crop governer
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Theman on July 06, 2005 at 07:43:14 from (65.248.77.5):
In Reply to: 300 row crop governer posted by Texp on July 05, 2005 at 18:53:59:
In your governor, the spring accelerates the engine and the fly weights slow it down. If it won't return to idle then is sounds like there is a mechanical bind somewhere. Pull the cover off of the side and make sure the thrust bearing and sleeve slide on the shaft easily. The other place to check is the pivot yoke needle bearings. There should be no sign of binding as you move it up and down by hand. Also make sure the weights can swing freely. I have seen the rod that weight swivels on come loose and cause binding.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|