W-30 / F-30 carb overhaul question

Posted by Pete in Holland, MI on July 03, 2005 at 22:13:59 from (24.231.248.86):

In the midst of a carb overhaul and have a couple questions:

1) When reassembling the die-cast venturi into the housing, is there an orientation that must be followed (radially? )

2) Throttle butterfly plate........How much daylight is too much around the hole ?

3) There's a little brass tube that apparently allows suction of gas from the bowl. Tube appeared to have been criped into the threaded nut portion and was loose. I assume this joint should be tight?

4) Tractor would not idle down where it should prior to the rebuild. Idle screw was fully backed out. Any areas of the carb that may be allowing the engine to run faster that I need to pay attention to ?

Thanx......

Follow Ups:

• Re: W-30 / F-30 carb overhaul question Bobcat 08:18:26 07/04/05 (0)
• Re: W-30 / F-30 carb overhaul question Bob 23:42:24 07/03/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]