Re: what head work is needed when ringing M???

Posted by El Toro on June 30, 2005 at 12:35:53 from (64.12.117.13):

In Reply to: what head work is needed when ringing M??? posted by scruffyia on June 30, 2005 at 09:04:44:

I would have a valve job done on the head. Need to replace any valves that are too thin and guides
should be replaced since they can contribute to
oil usage. I would use a glaze breaker in the cylinders and then install a new ring in those
cylinders to see what the ring gap is, should be between .010" -.020". Excessive ring gap would require a new sleeve kit. Hal

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]