Re: New seat back rest 350 ute?

Posted by Janicholson on June 28, 2005 at 16:03:22 from (66.173.50.146):

In Reply to: New seat back rest 350 ute? posted by iester on June 27, 2005 at 19:50:19:

I f I remember ours (long gone) it had a slightly curved rear tube running up and around the rear with a rectangular piece of metal on it that was also slightly curved. If your new rest is curved, just use short ~1/2" long #10 stainless steel sheetmetal screws in the holes in the metal plate. If the new one is not curved, I'd make a curved shim from old tire sidewall rubber belt sanded to make up the gap. Only use screws long enough to get into the plywood of the new back. or kidney damage may occur when the point sticks through the cushion!!!!
Lots-O-luck Jim Nicholson

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]