Drawbar Measurement

Posted by Pharmall on June 23, 2005 at 02:54:27 from (68.9.106.167):

In Reply to: Help...Measurement needed posted by Eastsider on June 22, 2005 at 13:58:25:

This is a picture of the drawbar plate that was on a '48 C I
picked up last year. Picture is taken looking at the bottom of the
drawbar assembly. Don't know if this was original or if there
were different types, but it looks like the picture in the parts
manual (PN 351 232 R1). Perhaps some of the more
experienced folks here could tell. The large holes are on 2 7/8"
centers. The small hole is 1 1/8" on center to the nearest large
hole. It was a little tough to measure, as the holes are a bit egg-
shaped. Obviously the center-to-center should match the
distance between the two mounting holes on your drawbar. Jeff

Follow Ups:

• Re: Drawbar Measurement Eastsider 09:12:17 06/23/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]