|
Farmall & IHC Tractors Discussion Board |
Re: Scratching my Sunburned head in frustration
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Janicholson on June 20, 2005 at 12:19:38 from (199.17.6.63):
In Reply to: Re: Scratching my Sunburned head in frustration posted by Nebraska Cowman on June 20, 2005 at 10:33:36:
Try this before gutting the best air cleaner made! with cleaner off, start engine (you said it was not a problem) Attach the rubber hose only (not attached to Air cleaner) If still running attach air cleaner housing (holding it in your hands, not bolted on) if still running, put the oil cup w/oil on the bottom. If still running try bolting it on. If still runing all is well. If it stopped, maybe you streched a wire or crimped something. These things don't break. If you have fuel in the aircleaner mesh, and it is not entirely dried out, it will be flooded beyond starting just from the excess evaporation. it must be dry of fuel. Good luck, don't give up. JimN
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|