Re: T20 manifold ?

Posted by Canetractor on June 18, 2005 at 19:57:18 from (216.78.98.171):

In Reply to: T20 manifold ? posted by Nebraska Cowman on June 17, 2005 at 18:27:36:

The difference in F-20 and T-20 original all fuel manifolds is the controll linkage for heatriser. The T-20 uses a stud a few inches up from carburetor for a lever to change direction of control to up motion (bellcrank). Why is this needed ? Because the operators manifold heat lever is positioned much lower on crawler. Notice on F-20 all fuel manifold a boss or mounting pad down near carburetor but not drilled and tapped (about the size of a nickle). The same basic manifold is used on both.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]