H carb rebuild

Posted by bhb on June 15, 2005 at 18:24:03 from (69.174.116.30):

I am rebuilding the carb on my H. The kit that I have has a idle jet that is about 3/4 inch long by 1/8 inch. It has treads on one end and has a screw driver slot on the other end and a hole about .005 inch. I read in the archives, by Rebuild, that it goes by the idle screw. If you look at the bowl section of the carb with the idle screw away from you, you will see two holes to the left of it. The hole next to the idle screw is 1/4 inch with a brass tube, with a 1/16 inch hole, flush with the bottom of it. The one to the left of that is 3/16 hole with a plate in it with about .005 hole. Is the 1/4 inch the one that the jet is susposed to be in? I don"t want to start drilling if I am in the wrong place. I have two carburators, 50981DC and 45108DD, they are both the same with a tube flush with the bottom of the 1/4 inch hole. Thank you in advance, Bill

Follow Ups:

• Re: H carb rebuild bhb 09:00:32 06/16/05 (0)
• Re: H carb rebuild Theman 06:51:59 06/16/05 (0)
• Re: H carb rebuild Nebraska Cowman 06:40:00 06/16/05 (0)
• Re: H carb rebuild riverbend 20:25:58 06/15/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]