Re: B rocker arm bushings/blueprints specs?

Posted by Pharmall on June 14, 2005 at 16:19:02 from (68.9.106.167):

In Reply to: B rocker arm bushings posted by BobOH on June 14, 2005 at 15:47:50:

It would be possible, but unless you are going to do the
machining yourself or barter, it would probably cost a lot more.
The stock material cost is about $20 (leaded phosphor bronze
rod - C544), but at $50/hr, the machining could be several
hundred dollars for a full set. If we knew the original size there
might be a less expensive generic bushing available from a
company like W.M. Berg, Timken, or McMaster-Carr.

Which brings up a question - does Case/IH still have control of
the original prints?

Follow Ups:

• Re: B rocker arm bushing measurements BobOH 16:36:31 06/14/05 (2)
  • Re: B rocker arm bushing measurements Pharmall 17:05:31 06/14/05 (1)
    • !!Correction!! - Bushing ID Dimension Pharmall 17:12:55 06/14/05 (0)
• Re: B rocker arm bushings/blueprints specs? Paul in Mich 16:24:06 06/14/05 (1)
  • Re: B rocker arm bushings/blueprints specs? BobOH 20:45:49 06/14/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]