|
Farmall & IHC Tractors Discussion Board |
Questions about my 826.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Monty Feagley on May 29, 2005 at 08:33:09 from (4.225.178.99):
I have a 1970 IH 826 Diesel that I am beginning a refurb and have a few questions. I need to confirm the voltage and cold cranking amps on this thing in order to get the right batteries. I think that it is a 6-volt system, but not sure. The ether assist never worked, but I would like to get it into working order prior to selling. I have no idea what I am looking at as far as how to troubleshoot it and figure out what to replaced. I have looked on a few websites that retail parts for IH's and have found nothing and have checked at all of the salvage yards in my area (NE Texas) with no luck on an 826. Anyone know of any online sources. Also, will it cross over to any other models as far as parts? The tractor has been setting up without being cranked for over seven years (I know, I know) and I was wondering if I needed to go to any further lengths other than changing the oil, oil filter, drain fuel system, fresh fuel and fuel filters. Do I need to add an upper cylinder lube or such? Should I turn it over by hand before trying to crank it? I also have a question about painting the tractor.
On the parts that are not sheet metal... will Simple Green or such product sufficiently prep the surface or do I need to take further steps? Sorry for the long line questions. But I will probably have more as I go. I hope that the good members of this forum will indulge me. Monty
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
