|
Farmall & IHC Tractors Discussion Board |
Re: certainly no disrespect intended
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan in NE on May 21, 2005 at 07:22:14 from (148.78.243.25):
In Reply to: Re: certainly no disrespect intended posted by Bob Frey on May 21, 2005 at 06:59:24:
Bob, Looky here, seems to me we're now going in circles, as I recall you were one of the guys that led me by the hand. :>) Okay, here I go again. My torque motor was a used one off a M that was setting in a salvage yard. It works fine unless I get up against the stops, then it "seeps" out the upper shaft seal. Did you just replace the complete motor or did ya reseal it? Looks like a bugger to rebuild? Maybe I'm just getting old 'er something, but I'll never own another tractor without that power steering. My little H is a pure "joy" to run under the loader and now acts just like one of the big boys. Little stinker impresses me every time I crawl on it. :>) Allan
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Mud Daubers and the Old John Deere - by Jon Zehnder. I have a 1941, John Deere Model A tractor I have owned for about a year and a half. This is my first (in case my wife reads this, "FIRST") tractor and it has been a learning experience. After considerable advise and assistance from local tractor nuts and the forums of Yesterday�s Tractors, I had finally got it running pretty well. I have tuned it up, overhauled the carburetor, installed a borrowed, rebuilt magneto, installed a new Power-Trol, patched the radiator, installed new front wheels a
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|