|
Farmall & IHC Tractors Discussion Board |
450 gas stuck engine
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Billy D on May 16, 2005 at 16:49:36 from (64.12.117.13):
Just bought a farmall 450 for 1,400 dollars, Good buy but found out from the owner that the motor was slightly stuck meaning that this happened to him before and he just poured in a little diesel fuel and loosened it up before. I bought it cause I was told not to let a deal like that get past me but after soaking the pistons with pb blaster and then with tranny fluid I still can"t get it to move. I took the oil pan off and felt up into the sleeves and the only ones with a little scaley rust are the two middle pistons. The rust is only on one side of the sleeves. Is there anything I can do short of pulling off the head and beating on the pistons with a block of wood and sledge hammer. I need help. Also the motor has freshly been rebuilt and is nice and clean except for this problem. Thanks for your help
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
