Farmall & IHC Tractors Discussion Board |
Re: 6600
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by captaink on May 11, 2005 at 15:20:13 from (66.115.214.56):
In Reply to: 6600 posted by Likes the Farm NC on May 11, 2005 at 05:47:35:
A late model 6600 combine will be a lot more than you will need for 50-75 acres, as it will cover that in three days or less depending on the crop. I had one and we could run out about 500 Bu of corn per hour stopping to unload on the end of the field. In soybeans and small grain I covered about 35-45 acres per day depending on how early/late we could run. I used to run it on about 1200 acres of corn, beans, and wheat. If you could find a nice one for a cheap price, (around here you can buy them for under $3500) put it in a shed and do a little custom work to keep it in shape it would probably pay for itself. As far as parts, the 6600 and 6620 had a lot of the same “wear” parts and the others could be fabricated. Setting outside under a tarp and not being used a combine like that will deteriorate in 5-10 years into basically scrap. If you can’t shed it, I would suggest waiting until closer to the time you will actually need it before purchasing, as you might be able to get a newer model. As far as the tax deduction, if you’re not actively farming and using it in your business I have to believe you’d have a hard time convincing an IRS auditor that it was legitimate.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|