Re: Proper direction of a thermostat on an M

Posted by Janicholson on May 09, 2005 at 09:40:13 from (199.17.6.175):

In Reply to: Re: Proper direction of a thermostat on an M posted by Nathan in Texas on May 09, 2005 at 07:49:28:

Old, and Bob are correct, wax pellet toward heat source (enging). The bypass passage may allow enough hot coolant to get to the other side of the stat, that it might open either way!! however Before ripping it out again, I'd use the tractor doing a bit of field work to see if it does over heat. I also believe boiling your gauge sender is important before field testing. Cracking a head or ruining the enging because the gauge didnt read reasonably is bad economy. Good luck JimN

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]