Re: Levers

Posted by Janicholson on May 09, 2005 at 07:57:05 from (199.17.6.175):

In Reply to: Levers posted by PAULIH300 on May 07, 2005 at 16:40:43:

Paul, My best guess is that you are correct on the B.O. reality. Our 350U gas has had several lever changes. The insert on the splined shaft would break loose from the aluminum and slip. I think it is because of the angle (or offset of the knob to the right of the centerline of the shaft). Our fix was to drill three 3/16 holes (in a good drillpress with a stub drill) in three places around the insert, half in the aluminum, half in the steel. then we put tight fitting roll pins in the holes and grind them flat to the sides. Just remembering what we did. LOL on a new set.
JimN

Follow Ups:

• Re: Levers earl in pa 18:52:47 05/09/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]