|
Farmall Tractors Discussion Board |
Re: parked A for 13 years
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Rick Wisehart on December 11, 1999 at 21:03:46 from (63.82.131.59):
In Reply to: parked A for 13 years posted by nate on December 10, 1999 at 19:43:46:
Start by removing the head,use alot of WD 40 in each cylinder to soak the pistons.If this motor has been stuck for 13 years your going to need a valve job to ever make it run right.also depending on if the motor has had water in it you my need to pull the pistons because the rings will be stuck to.After about a week of soaking the pistons,use a hammer and a block of wood and tap each piston not hard but with firm presure.This should free the motor if not keep trying with the WD40 hammer and wood it will in time give up. If you are going to keep the tractor then you are going to need to do it the right way to make the motor run good,just a little more to it then just air presure.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|