|
Farmall & IHC Tractors Discussion Board |
Re: Farmall H Exhaust Manifold
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the preacher on May 07, 2005 at 17:19:52 from (69.168.33.224):
In Reply to: Farmall H Exhaust Manifold posted by Tweeter on May 07, 2005 at 17:02:21:
the exhaust manifold will most likely either have to be welded, or replaced. be careful pulling the tractor to break it loose, you run the risk of breaking something, or bending a rod. do a search here under stuck engine, there are about a million different home remedies.the leak at the radiator is most likely the drain tube. if you're lucky, it will reseal just fine. if not, well, you get the idea. remember, this thing is 50 plus years old, so it's going to put up a fight. but remember, it's just a piece of iron. i'm going through the same trouble with the one i just bought my girlfriend. good luck.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|