Farmall & IHC Tractors Discussion Board |
Re: I'm confused about wiring an A regulator
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on May 04, 2005 at 18:51:56 from (66.43.221.243):
In Reply to: I'm confused about wiring an A regulator posted by Georgia Boy on May 04, 2005 at 09:54:28:
I think he made a mistake. With a cut-out field goes to field on the cutout. Bat on the cutout goes to the amp meter on the side that goes to the starter sw. ARM on the gen goes to the gen post on the cutout and the wire from the light sw with the resistor goes to the field on the cutout. I have 8 tractors As and Bs this way. They are all original set ups with the DELCO REMY cutouts and of course positive ground. The wire coming from the resistor post is for the hi-charge position on the light sw on the steering post. Been running them this way as per the wiring diagram in the manual for more yrs than i can remember.
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|