|
Farmall & IHC Tractors Discussion Board |
Re: SA hydraulic problem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike@NY on May 04, 2005 at 01:16:46 from (24.58.224.75):
In Reply to: SA hydraulic problem posted by mchief on May 03, 2005 at 23:32:33:
My C was doing the same thing at one point. I belive the Hydraulic pump probably just needs new seals (rebuild kits are available, usually for your local Case/IH dealer), or, like my pump, there is an issue with the shaft in the pump, where there may be a bur on it or the hole is worn and a bushing is needed. I put a kit into mine, and it worked for about 2 weeks, then it all leaked out again. We determined there is an issue with the shaft on mine, just haven't gotten it fixed yet. I pulled the gear off the pump so I didn't burn up the pump and I can still get some use out of the tractor. I am sure others will jump in here as well. Hope this helps some. Good Luck.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Harvestin Corn in Southern Wisconsin: The Early Years - by Pat Browning. In this area of Wisconsin, most crops are raised to support livestock production or dairy herds in various forms. Corn products were harvested for grain, and for ensilage (we always just called it 'silage'). Silo Filling Time On dairy farms back in the 30's and into the first half of the 40's, making of corn silage was done with horses pulling a corn binder producing tied bundles of fresh, sweet-smelling corn plants, nice green leaves with ear; the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|