Re: what should a fella pay for a farmhand loader,

Posted by MM_TX on April 16, 2005 at 18:22:14 from (69.152.234.236):

In Reply to: what should a fella pay for a farmhand loader, H posted by arod on April 16, 2005 at 13:31:45:

I paid $350 for a F-11 with 2 spool valve that I probably should
have walked away from, but in Tx cheap loaders are very hard to
find. Big cylinders are good, missing one bucket cylinder. All the
pins are cobbled to an embarrassment and I will have to do
some reconstructive fabrication and it will allways be a patched
up loader, not a clean one. If those big cylinders have bad pits &
rust on the shafts its not worth much as they will tear up new
seals and are expensive to replace. If the bucket is no good the
F-11 has wider pins than most so finding a cheap one will
probably take adding brackets. Look at the pins for patches
and wear and decide if Its useable or just cheap yard art.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]