|
Farmall & IHC Tractors Discussion Board |
Re: Historical Farmall Motor Question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George 2 on April 09, 2005 at 17:38:40 from (216.46.141.114):
In Reply to: Re: Historical Farmall Motor Question posted by Bill in NC on April 09, 2005 at 17:16:05:
Bill: Two different motors were used in the F12. The very early ones used a Waukesha flat head motor and was used in 1932 and part of 1933. From 1934 onwards IH used its own valve in head engine of the same 113 cubic inch displacement. There have been various discussions of why IH did it that way. If I remember right there was an article in Red Power Magazine a while back that describes the issue well.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Pop's Tractor of Gold - by Gary Teate. My father was a simple man but could repair just about anythin mechanical that was ever made. From the time I was a young boy growing up in Jacksonville, Florida, I would spend a considerable amount of time helping my father repair or rebuild equipment and engines, etc. on our 2 1/2 acre "spread". Pop always dreamed of having more acreage out in the country where he could retire and tinker as much as he wanted and often reminisced about his boyhood days on his grandfathers farm in Montecello,
... [Read Article]
Latest Ad:
1952John Deere MT tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
