|
Farmall & IHC Tractors Discussion Board |
Re: h farmall bearing noise or ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by williamf on April 09, 2005 at 15:00:24 from (66.82.9.74):
In Reply to: h farmall bearing noise or ? posted by cjbastin on April 09, 2005 at 11:59:20:
My H does the same thing, in every gear but fifth. That, and where it sounds to me that the noise is originating makes me think that my culprit is the constant mesh gear. IH's "Blue Ribbon Service Training Course Serviceman's Guide" warns of gear whine if the backlash and tooth contacts are not set perfectly when the gears are new. It has instructions for setting them, using red lead mixed with a little oil and applied with a stencil brush to the teeth to check the contact. I'll quote,"This is so important because gears will not wear in, nor will they improve with use. Rough spots, of course, will wear down and teeth will become smooth; but, if they are noisy and are operated continuously that way, there is little possibility of their ever operating quietly even after an attempt is made to reset them. The responsibility is with the serviceman to do a perfect job every time. Use only matched sets of gears for replacement purposes, take the time to set them properly and the life and efficiency of the parts will be materially increased." A long quote I know, but just reading the quality of the writing in these old manuals makes me feel better. I can't imagine in this day a service instructor's knowing to use the possessive with a nominative gerund. Anyway, it leads me to believe that, in my case at least, there's nothing to be done at this point and it likely won't get worse in my lifetime. That said, maybe you should check your gear oil for metal flakes and chunks next time you change it. Good luck, Wm
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|