Re: Need help with ring gear pinion adjustment

Posted by the tractor vet on April 07, 2005 at 18:53:09 from (4.124.70.130):

In Reply to: Need help with ring gear pinion adjustment posted by Marv on April 07, 2005 at 18:04:02:

Yes , do you have the deck off the tractor???? There are shims under the bull pinions housings . You may have other problems and it is best to look over eveything before you start moving shims . You may have a bearing or two going south . I just got done with one S/MTA that had a bull pinion bearing go out and found that the other three were on there way so if i am going to do one just might as well do the others . The guy that owens this one is starting to have bearing problems and we are going to have to go in and replace all of them sooner or later it started with and inside axel bearing back a couple years ago then the other side went a littel later now this next it will be the pinion and trans.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]