Re: Splitting stands

Posted by Kelly C on April 03, 2005 at 06:38:02 from (63.171.43.140):

In Reply to: Splitting stands posted by FarmerSid on April 02, 2005 at 15:36:36:

Here is a simple one for the front. Took me about 1/2 hr to cut it drill and use it.
Just take 2 4inch x4 inch 1/4 inch angle iron.
2 12 inch grade 8 threaded rods
4 nuts
2 4x4 inch flat steel.

Cut 2 or 3 inches off the angle iron. Weld them into a square. Drill 3/4 inch hole in the 2 flat steels. weld a bolt onto each. Weld a bolt or what ever to the bottom of the threaded rod. wheels would be great. I used a nut because thats what I had on hand.
For the rear I just used a regular floor jack with cribbing. I did buy a used pallet jack and will be using that on my 460 next time.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]