Farmall Tractors Discussion Board |
Re: Now about this bad PTO seal....
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Phil Auten on December 07, 1999 at 06:20:30 from (206.175.72.226):
In Reply to: Now about this bad PTO seal.... posted by Farmall Newbie on December 06, 1999 at 14:07:38:
FN, I just did this to my '49 M. Took less than an hour. Got the parts from Beecham Equipment in Marlin, Tx. The counterman immediately knew what I needed and came back with a kit containing two seals and the gasket for the seal "holder". He told me, and I'd already been told by others on this site, to use both seals. I drove the old seal out and found that it was over 1" thick and had two "lips" inside. I reinstalled the new seals so they touched slightly different spots on the shaft than the old seal and no more gear lube puddles under the M. Use both seals, be sure to install them correctly (with the sealing lip inside) and you'll have no more problems. Do be sure to check the bearing as RedBlooded said and you'll be back to work quickly. Phil
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|