Re: Hey r4etired v-8 M

Posted by r4etired on March 29, 2005 at 18:56:56 from (64.12.117.13):

In Reply to: Hey r4etired v-8 M posted by Mike in shenadoah valley on March 29, 2005 at 09:26:09:

Alignment is determined by the drilling of the rear engine support on the M, that you bolt the 345 to. We did a 345 in a 560 prior to my M. I transfered the 345 engine to the 560m by making a plastic template out of 1/8in clear plastic , All measurements must come from the center of the crankshaft.The same template I made for the 560 worked perfect on the M, I measured up a 450 being I have another 345 and my drill template is the same for it also. I loaned my template to a guy out of state, hope I get it back

Follow Ups:

• Re: Hey r4etired v-8 M Mike in shendoah valley 08:47:03 03/30/05 (0)

Post a Followup Name: E-Mail: Hide: Yes No Hiding your address protects you from spam generators but allows you to receive email response notifications. Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]