|
Farmall & IHC Tractors Discussion Board |
Re: Will Ya Take A Peek At This!!!!!!!!!!!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on March 19, 2005 at 23:07:39 from (216.208.58.164):
In Reply to: Will Ya Take A Peek At This!!!!!!!!!!!! posted by Allan in NE on March 19, 2005 at 15:27:49:
Allan: I have a question for you and indeed everyone else involved in this thread along with a few others. What do you find so exciting about 66 series tractors? My opinion is they were ugly, and statistically not near as good of tractor as the 56 series were. I bought one new 66 series tractor and can assure you it will be the last. If I had a use, I would buy another 56 series tractor. When I farmed I had at least one new tractor from each series starting with letter series right through to 66 series. I can take you to countless farms that through the years were IH customers and indeed still are CaseIH customers. Just to give you an example, I have a neighbor with three newer CaseIH. He still has his 856 and three letter series tractors. His two 66 series were traded off quite quickly. Another guy not far away has his 856 and Super M, but his 66 series tractors he bought new have been replaced by new Deeres. I see this all over this area, the older IH tractors are still on the farms that bought them new. I was rather curious where all the 66 series tractors went to, so started asking. Dealer told me many were trucked back to US, they love them down there. Then one day I was at a huge scrap yard just north of here. That answered a lot of my questions. Most prominant grill sticking out of pile was 66 series. Didn't see any 56 and only a couple of 06. All this has me rather curious, why 66 is still so popular south of the border.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|